Solutions Database

---

Xsimmake patch needed for Workview Office (Windows 95 and NT)

Record #1239

Product Family:  Software

Product Line:  FPGA Core

Problem Title:
Xsimmake patch needed for Workview Office (Windows 95 and NT)


Problem Description:
When Viewlogic developed Workview Office, they changed the name of the
DOS-based VSM executable.  They did this to give the name VSM.EXE to the
Windows-based GUI.  Therefore the old VSM.EXE became VSM_NGUI.EXE.  This
has caused a problem with XSIMMAKE, because it calls VSM.EXE and expects it
to be the DOS version.  Hence the need for the patch.

This patch also fixes some errors that are encountered in VSM and VSMUPD.

This patch was tested with Workview Office 7.2, but is intended for all of
the Windows 95/NT versions of Workview Office, including 7.3.x and 7.1.x
(except WVO 7.1.2, which is for Windows 3.x).


Solution 1:

Download the file WVOSIM.ZIP from the Software Help -> Viewlogic area of the
BBS.  The FTP address is ftp://ftp.xilinx.com/pub/swhelp/viewlogic.
Replace c:\xact\data\xsimmake.xfw with the one in this zip file.

Make sure you keep the original Viewlogic names of VSM.EXE and VSM_NGUI.EXE.
If you have changed them to work around this problem, please change them
back, as these are what the new xsimmake.xfw expects.  Don't forget to
change Tools -> Create Digital Netlist in Viewdraw back to VSM.EXE.

One final note - if you are running a timing simulation with the
S<DESIGN>.VSM file and you do not see the data annotated to the sdesign
schematic, run this command at the Viewsim prompt:

schemnan sdesign

where sdesign is the name of your top-level design prepended by an "s".
You can even add this to your command file.


Note:  This patch does not address error 8037, which may occur if your
license is on a network and you do not have a local hardware key.  Viewlogic
is still looking into this problem.



End of Record #1239