                     -----  W A R N I N G  -----
For the installation procedure to work, two conditions must be true:

1) The IBM program 'RESTORE.COM' must be on the DOS search path.

To see if this is true, enter the command 'PATH'
at the DOS prompt on the hard disk.  PATH will respond with either:
  a) 'No path', or
  b) 'PATH=' followed by a list of directories (the 'path directories')
For RESTORE.COM to be 'on the path',
  * a PATH must be in effect (response 'b' above), and
  * RESTORE.COM must be on one of the path directories
If both of these are true, you can proceed with installation.  Otherwise:

* If no path is set ('a' above), set a temporary path by entering 'PATH \'.
  You can verify that the path has been set by entering 'PATH' again.
  This time, PATH should respond 'PATH=\'.
* If RESTORE.COM is not on the hard disk, copy it from the DOS SYSTEM
  diskette to one of the path directories.  (If you just entered 'PATH \',
  copy it to 'C:\', the root directory of the hard disk).
* If RESTORE.COM is already on the hard disk, copy it from its present
  directory to one of the path directories.  (If you just entered 'PATH \',
  copy it to 'C:\', the root directory of the hard disk).

2) No resident programs such as Borland's 'SideKick' should be installed.
   (SideKick is one resident program which interferes with RESTORE.COM).
   If your \AUTOEXEC.BAT file installs any resident programs, you
   should temporarily change your \AUTOEXEC.BAT file to disable
   their installation, reboot the PC, install the VSP Simulator,
   then undo the changes to \AUTOEXEC.BAT.

